JIANG Hai-tao
,
DING Wei
,
TANG Di
,
HUANG Wei
钢铁研究学报(英文版)
Mechanical properties and microstructure in high strength hot dip galvanizing TRIP steel were investigated by optical microscope (OM), transmission electron microscope (TEM), X-ray diffraction (XRD), dilatometry and mechanical testing. On the heat treatment process of different intercritical annealing (IA) temperatures, isothermal bainitic transformation (IBT) temperatures and IBT time, this steel shows excellent mechanical properties with tensile strength over 780 MPa and elongation more than 22%. IBT time is a crucial factor in determining the mechanical properties as it confirms the bainite transformation process, as well as the microstructure of the steel. The microstructure of the hot dip galvanizing TRIP steel consisted of ferrite, bainite, retained austenite and martensite during the short IBT time. The contents of ferrite, bainite, retained austenite and martensite with different IBT time were calculated. The results showed that when IBT time increased from 20 to 60 s, the volume of bainite increased from 14.31% to 16.95% and the volume of retained austenite increased from 13.64% to 16.28%; meanwhile, the volume of martensite decreased from 7.18% to 1.89%. Both the transformation induced plasticity of retained austenite and the hardening of martensite are effective, especially, the latter plays a dominant role in the steel containing 7.18% martensite which shows similar strength characteristics as dual-phase steel, but a better elongation. When martensite volume decreases to 1.89%, the steel shows typical mechanical properties of TRIP, as so small amount of martensite has no obvious effect on the mechanical properties.
关键词:
TRIP steel
,
isothermal bainitic transformation
,
martensite
,
mechanical property
许传龙
,
王式民
工程热物理学报
在加压密相气力输送实验装置上获得了不同操作条件下煤粉颗粒静电波动信号,并用Hilbert-Huang变换、功率谱进行分析.结果表明:随着表观速度的增加,静电波动信号主峰值的频率增大;静电波动信号希尔伯特-黄变换(Hilbert-Huang)揭示了气固两相流静电信号的非线性和非平稳特征,随气固两相流颗粒相浓度降低和颗粒及表观速度增加,静电波动信号特征尺度由高尺度(低频)向低尺度(高频)转移.多尺度分析有助于认识气固两相流动形态及其转变规律.
关键词:
颗粒静电
,
静电传感器
,
气-固两相流
,
Hilbert-Huang变换
X.B. Tian
,
X.F. Wang
,
A.G. Liu
,
L.P. Wang
,
S. Y. Wang
,
B. Y. Tang and P. K. Chu 1)Advanced Welding Production & Technology National Key Laboratory
,
Harbin Institute of Technology
,
Harbin 150001
,
China 2)Department of Physics & Materials Science
,
City University of Hong Kong
,
China
金属学报(英文版)
The research on plasma immersion ion implantation has been conducted for a little over ten years. Much is needed to investigate including processing technlogy, plasma sheath dynamics, interaction of plasma and surface, etc. Of the processing methods elavated temperature technique is usually used in PIII to produce a thick modified layer by means of the thermal diffusion. Meanwhile plasma ion heating is more recently developed by Ronghua Wei et al[1]. Therefore the temeperature is a critical parameter in plasma ion processing. In this paper we present the theoretical model and analysize the effect of imlantation voltage, plasma density, ion mass,etc on the temperature rise.
关键词:
plasma immersion ion implantation
,
null
,
null
夏小建
量子电子学报
doi:10.3969/j.issn.1007-5461.2009.06.010
采用Wei-Norman方法,求出含时变电压源的介观LC电路随时间演化的精确解,应用相空间准概率分布函数,研究了时变电源作用下介观LC电路相干态的量子特性,结果表明此函数是一个二维运动的Gauss波包,其中心电量和磁通呈余弦和正弦变化.
关键词:
量子光学
,
LC回路
,
介观电路
,
相干态
,
量子态演化
,
相空间的准概率分布函数
中国腐蚀与防护学报
N。1Atmospheric Corrosivlty for Steels………………………………………………… .LIANG Caideng HO[I i。-tat（6）Caustic Stress Corrosion Cr。king of Alloy 800 Part 2.The Effect of Thiosul执e……………………………………… KONG De-sheng YANG Wu ZHAO Guo-zheng HUANG De.ltL。ZHANG Yu。。he CHEN She。g-bac（13）SERS slid E16CttOCh6iniC81 Stlldy Of Illhibit1Oli M6ch＆tllsth Of ThlollY68 Oil ITOll ID H....
关键词:
Materials Science and Engineering a-Structural Materials Properties Microstructure and Processing
Monocrystalline copper samples with [001] and [221] orientations were subjected to shock/recovery experiments at 30 and 57 GPa and 90 K. The slip system activity and the microstructural evolution were investigated. Different defect structures, including dislocations, stacking faults, twins, microbands, and recrystallized grains were observed in the specimens. The residual microstructures were dependent on crystalline orientation and pressure. The differences with crystalline orientations are most likely due to different resolved shear stresses on specific crystalline planes. The geometric relationships between the shock propagation direction and crystalline orientation are presented under uniaxial strain. It is shown that the [2 2 11 orientation, by virtue of having fewer highly activated slip systems, exhibits greater concentration of deformation with more intense shear on the primary system. This, in turn leads to greater local temperature rise and full recrystallization, in spite of the thermodynamic residual temperature of similar to 500 K and rapid cooling (within 20 s) to ambient temperature. The profuse observation of microbands is interpreted in terms of the mechanism proposed by Huang and Gray [J.C. Huang, G.T. Gray III, Acta Metallurgica 37 (1989) 3335-3347]. (C) 2009 Elsevier B.V. All rights reserved.
关键词:
Shock compression;Shock loading;Slip bands;Microtwins;Microbands;strain rate history;single-crystals;grain-size;constitutive;description;plastic-deformation;mechanical response;deformed metals;loaded nickel;substructure;recrystallization
WEI Jihe Xi'an Institute of Metallurgy and Construction Engineering
,
China.
材料科学技术（英）
The oxidation of alloying elements during the ESR of stainless steel has been studied. The model previously developed by WEI and Mitchell for the chemical reactions and mass transfer processes during ESR was applied to the remelting of the high Cr steel 1Cr18Ni9(Ti).The laboratory data for the unsteady state A.C.ESR were analyzed and dealt with by the model.When the remelting process reached a steady state,an oxidant(Fe_2O_3 powder)or a deoxidant(Ca-Si powder or metallic Ca)was added to the slag bath.The results showed that this model is applicable to the remelting of stainless steel rather precisely, and it is expected that the model may offer a reliable basis for the control of composition during practical ESR of high alloy steel. Also,the oxidation of Cr in the steel must be noticed when its content is high;but it is entirely possible to adjust the Cr content of ingot within a considerable range,using a special technique by means of the slag-metal reactions during the remelting.
关键词:
ESR
,
null
,
null
,
null
,
null
Physical Review B
An elastic Ising model for CoMnO(6) chain is proposed to explain the ferroelectricity induced by collinear magnetic order in Ca(3)CoMnO(6), and then a mean-field theory with interchain spin interactions based on this model is developed. With inclusion of the dynamics of polarization domains at finite temperature, we address the rationality of our theory by the good agreement of the calculated electric polarization and dielectric susceptibility with the reported data on Ca(3)Co(2-x)Mn(x)O(6) (x approximate to 0.96) [Y. J. Choi, H. T. Yi, S. Lee, Q. Huang, V. Kiryukhin, and S.-W. Cheong, Phys. Rev. Lett. 100, 047601 (2008)], a typical diatomic Ising spin chain system, while the predicted magnetic susceptibility shows some difference from experiment, the reason of which is discussed.
关键词:
calcium compounds;cobalt compounds;dielectric polarisation;ferroelectricity;Ising model;magnetic susceptibility;multiferroics;optical susceptibility;one-dimensional oxides;magnetic-properties;multiferroics;ca3co1+xmn1-xo6
